Section 5: Setup; Unpacking; Piece Inventory - Grizzly G0516 Owner's Manual

Unpacking

This combination lathe/mill is shipped from the
manufacturer in a carefully packed crate. If you
discover the machine is damaged after you've
signed for delivery, and the truck and driver are
gone, you will need to file a freight claim with
the carrier. Save the containers and all packing
materials for possible inspection by the carrier
or its agent. Without the packing materials, fil-
ing a freight claim can be difficult. If you need
assistance determining whether you need to file
a freight claim, or with the procedure to file one,
please contact our Customer Service.
The Model G0516 is a
heavy machine, 420 lbs.
shipping weight. DO NOT
move the machine by
yourself – you will need
assistance and power
equipment. Serious per-
sonal injury may occur
if safe moving methods
are not followed.
Some
may have sharp edges
on them after they are
formed. Please examine
the edges of all metal
parts
them. Failure to do so
could result in injury.
When you are completely satisfied with the con-
dition of your shipment, you should inventory its
parts.
G0516 Lathe/Mill

SECTION 5: SETUP

metal parts
before handling

Piece Inventory

Inside the crate you will find:
• Model G0516 Lathe Unit ................................. 1
• Mill/Drill Unit .................................................... 1
• Mill Chuck Collet Set ....................................... 1
• Faceplate Set ............................................... 1
• 4-Jaw Chuck Set .......................................... 1
• Tool Post Changer Set ................................. 1
• Milling Vise Set ............................................. 1
• Mill/Drill Table ............................................... 1
• Carriage Handle & Screw ............................. 1
• Apron Handle & Screw ................................. 1
• Locking Lever ............................................... 1
• Milling Machine Power Cord ......................... 1
• Eyeshield ...................................................... 1
• Hex Wrenches 3, 4, 5, 6, 8mm ..............1 Each
• Gears 70T ..................................................... 2
• Gears 75, 72, 68, 66, 65, 60T ............. 1 Each
• Gears 50, 48, 45, 40T ......................... 1 Each
• Fixed-Shaft Gear 40T ................................... 1
• 3-Jaw Lathe Chuck Key ................................ 1
• Drill Chuck Key ............................................. 1
• Combo Wrench 5.5/7, 8/10mm ............ 1 Each
• Combo Wrench 12/14, 17/19mm ......... 1 Each
• Wrench 36mm .............................................. 1
• 3 Outside Jaws ............................................. 1
• Dead Center MT#2, MT#3 ................... 1 Each
• Spanner Wrench 45-52 ................................ 1
• Toolpost Wrench ........................................... 1
• Oil Bottle ....................................................... 1
• T-Nuts ........................................................... 2
• Cap Screws M8-1.25 x 25 ............................ 4
• Mill/Drill Fuse 110V/5A ................................. 1
• Lathe Fuse 110V/25A ................................... 1
• V-Belt ............................................................ 1
• Cog Belt ........................................................ 1
-9-