Gigabyte GA-MA69VM-S2 User Manual page 61

(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to Section 4 if
you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl-F> to enter FastBuild (tm) Utility" (Figure 3). Hit the <Ctrl>+<F> key to enter the
ATI RAID BIOS setup utility.
RAID BIOS Version 2.5.1540.32
(c) 2006 ATI Technology, Inc. All rights reserved.
No Array is defined..............................
Press <Ctrl-F> to enter FastBuild (tm) Utility
Step 2:
Main Menu
This is the first option screen when you enter the ATI BIOS RAID Setup utility. (Figure 4).
To view the disk drives assigned to arrays, press <1> to enter the View Drive Assignments window.
To create an array, press <2> to enter the Define LD window.
To delete an array, press <3> to enter the Delete LD window.
To view controller settings, press <4> to enter the Controller Configuration.
FastBuild (tm) Utility (c) 2006 ATI Technology, Inc.
View Drive Assignments...........................[ 1 ]
Define LD..................................................[ 2 ]
Delete LD.................................................. [ 3 ]
Controller Configuration............................ [ 4 ]
Press 1..4 to Select Option
Figure 3
[ Main Menu] ]
[ Keys Available]
Figure 4
- 61 -
[ESC] Exit
Appendix