Gigabyte GA-MA69VM-S2 User Manual page 59

(2) Configuring SATA controller mode and boot sequence in BIOS Setup
You have to make sure whether the SATA controller is configured correctly in system BIOS Setup and
set BIOS boot sequence for the SATA hard drive(s)/RAID array.
Step 1:
Turn on your computer and press Del to enter BIOS Setup during POST (Power-On Self Test). In BIOS
Setup, go to Integrated Periperals. Ensure that OnChip SATA Controller is enabled. If you wish to
create RAID array, set OnChip SATA Type to RAID. (Figure 1).
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
IDE Configuration
OnChip SATA Controller
OnChip SATA Type
Onboard Audio Function
Onboard LAN Function
Onboard LAN Boot ROM
OnChip USB Controller
USB EHCI Controller
USB Keyboard Support
USB Mouse Support
Legacy USB storage detect
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
: Move Enter: Select
x ECP Mode Use DMA
F5: Previous Values
: Move Enter: Select
F5: Previous Values
The BIOS Setup menus described in this section may not show the exact settings for your
motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard
you have and the BIOS version.
Integrated Peripherals
[Press Enter]
[Enabled]
[RAID]
[Auto]
[Enabld]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
+/-/PU/PD: Value F10: Save
3
F6: Fail-Safe Defaults
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Figure 1
- 59 -
Item Help
Menu Level
Item Help
Menu Level
ESC: Exit F1: General Help
F7: Optimized Defaults
ESC: Exit F1: General Help
F7: Optimized Defaults
Appendix