Gigabyte GA-8VT880P Combo User Manual page 32

IDE Channel 2/3 Master
IDE HDD Auto-Detection Press "Enter" to select this option for automatic device detection.
Extended IDE Drive SATA devices setup. You can use one of two methods:
Auto Allows BIOS to automatically detect SATA IDE devices during POST. (Default value)
None Select this if no SATA IDE devices are used and the system will skip the automatic
detection step and allow for faster system start up.
Access Mode Use this to set the access mode for the hard drive. The two options are:
Large/Auto(default:Auto)
Capacity Capacity of currently installed hard disk.
Hard drive information should be labeled on the outside drive casing. Enter the appropriate option
based on this information.
Cylinder
Head
Precomp
Landing Zone
Sector
Drive A / Drive B
The category identifies the types of floppy disk drive A or drive B that has been installed in the computer.
None
360K, 5.25"
1.2M, 5.25"
720K, 3.5"
1.44M, 3.5"
2.88M, 3.5"
Floppy 3 Mode Support (for Japan Area)
Disabled
Drive A
Drive B
Both
GA-8VT880P Combo Motherboard
Number of cylinders
Number of heads
Write precomp
Landing zone
Number of sectors
No floppy drive installed
5.25 inch PC-type standard drive; 360K byte capacity.
5.25 inch AT-type high-density drive; 1.2M byte capacity
(3.5 inch when 3 Mode is Enabled).
3.5 inch double-sided drive; 720K byte capacity
3.5 inch double-sided drive; 1.44M byte capacity.
3.5 inch double-sided drive; 2.88M byte capacity.
Normal Floppy Drive. (Default value)
Drive A is 3 mode Floppy Drive.
Drive B is 3 mode Floppy Drive.
Drive A & B are 3 mode Floppy Drives.
- 32 -