Wireless - TP-Link TD-W8961NB User Manual

TD-W8961NB
between computers that request IP addresses and the DHCP server that assigns the
addresses. Each of the device's interfaces can be configured as a DHCP relay. If it is enabled,
the DHCP requests from local PCs will forward to the DHCP server runs on WAN side. To
have this function working properly, please run on router mode only, disable the DHCP server
on the LAN port, and make sure the routing table has the correct routing entry.
•
DHCP Server IP for Relay Age
side.
Note:
If you selec t Disabled, the DHCP function will not take effect.

4.3.3 Wireless

Choose "Interface S
Figure 4-14 ). Please configure the parameters for wireless according to the descriptions below.
300Mbps Wireless N ADSL2+ Modem Router User Guide
etup→Wireless" menu, and you will see the Wireless screen (shown in
Figure 4-13
nt: Enter the DHCP server IP Address runs on WAN
27