Installing And Removing The Data Card - Garmin GPSMAP 3205 Owner's Manual

A > I R D
PPENDIX NSTALLING AND EMOVING

Installing and Removing the Data Card

The GPSMAP 3205 uses optional preprogrammed Garmin marine BlueChart
g2 and MapSource data cards. The data card is installed in the card slot located
on the front left of the unit. Data cards can be installed or removed at any time,
whether the unit is on or off.
To install the data card:
1. Open the data card door by sliding the door in the direction of the arrow,
and lift the door open from left to right.
2. Insert the card into the slot, with the label facing the right screen and the
handle toward you.
3. Firmly push the card into the unit. It in not necessary to force the card and
about 1/2" is still exposed when it is properly inserted. If the unit is on, a
confirmation tone sounds and a message appears on-screen noting the
card details when the card is properly installed and accepted.
4. Close the cover until it locks.
If you insert a data card and get a card format not recognized message, remove
the card and reinsert it. If the card is still not recognized, contact Garmin Product
Support or your Garmin dealer for assistance. Data cards are not waterproof,
should not be exposed to moisture or excessive static charges, and should be
stored in the case supplied with the card.
The first time you insert a data card, the unit takes a few seconds to read the
card. After the data card is read, a summary page appears. Press ENTER to
acknowledge.
86
C
ATA ARD
Data Card Slot
Slide the data card door in
the direction of the arrow (to
the left) and pull to open it.
To remove a data card:
1. Open the data card door by sliding the door in the direction of the arrow,
and lift the door open from left to right.
2. Grasp the card handle and pull out firmly.
3. If the unit is on, a confirmation tone sounds when the data card is
removed.
PAGE
QUIT
ENTER
MARK
ADJ
NAV
MENU
MOB
DATA
CNFG
FCTN
FIND
GPSMAP 3205 Owner's Manual