Fujitsu FI-5750C Operator's Manual page 139

CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
7.1 Online setup
7.2 Double-feed detection
7.3 Setting of Page Edge Filler
7.4 Setting dropout color
7.5 Setting of pre-pick mode
7.6 Resetting the consumables counters
7.7 Adjusting the offset
7.8 Adjust the magnification
7.9 Power saving
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
7.1 Online setup (Continued from the previous page)
The following shows the contents of the setup:
No Meaning
Dropout Color
4
Pre pick
5
Consumable counter
6
Offset adjustment
7
Vertical magnification Adjustment
8
Power saving
9
All Rights Reserved, Copyright (C) PFU LIMITED 2003
Description
Use this function to drop out a color in
Grayscale or Binary mode.
Select "Yes" to enable Prepicking,
otherwise select "No".
You can estimate the service life of
consumables by checking these
counters. Be sure to reset the counter
when you replaced any consumable.
Set the horizontal and vertical offset for
scanning.
Set the magnification of a scanned
image.
Set the waiting time for the scanner to
switch into the power save mode
1 | 2
Selectable parameter The initial value
Red/Green/Blue/White Green
YES/NO YES
To reset
ADF(front)/ADF(back)/Flat bed
Main: -2 to 3 (can be changed by
Right & left : 0mm
0.5mm)
Top & bottom : 0mm
Sub: -2 to 3 (can be changed by
0.5mm)
ADF/Flat bed: -6.3% to 6.3%
0%
(can be changed by 0.1%)
You can set the waiting time
from 5 minutes to 55 minutes 15minutes
(can be changed by 5 minutes)