Figure 5-67: Igmp - Ip Multicast Reg Table; Figure 5-68: Igmp - Igmp Member Conf - Cisco SRW224P User Manual

24-Port 10/100 + 2-Port Gigabit Switch with Webview and Power over Ethernet
IP Multicast Reg Table
You can display the port members associated with a specified VLAN and multicast IP address.
Select a VLAN ID and the IP address for a multicast service from the drop-down menus. The switch will display all
the interfaces that are propagating this multicast service.

Figure 5-67: IGMP - IP Multicast Reg Table

IGMP Member Conf
Multicast filtering can be dynamically configured using IGMP Snooping and IGMP Query messages. For certain
applications that require tighter control, you may need to statically configure a multicast service on the switch.
First add all the ports attached to participating hosts to a common VLAN, and then assign the multicast service to
that VLAN group.
Specify the interface attached to a multicast service (via an IGMP-enabled switch or multicast router), indicate
the VLAN that will propagate the multicast service, specify the multicast IP address, and click Add.

Figure 5-68: IGMP - IGMP Member Conf

79
Chapter 5: Configuring the Switch through the Web Utility
IGMP