Where To Go From Here - Cisco 888 G.SHDSL Router with 3G - 888 G.SHDSL Router Hardware Installation Manual

Where to Go from Here

Table 2-4 Verifying Installation (continued)
Power/Link LEDs To Check
To digital LINE, CH1, CH1 RXD, CH1
telephone TXD, CH2, CH2 RXD, and CH2
TXD
To analog PH1 and PH2
telephone, fax, or
modem
1. You can also pick up the handset and listen for a dial tone.
Where to Go from Here
You have completed the hardware installation and are ready to configure the software. Cisco strongly
recommends that inexperienced network administrators use the Cisco 800 Fast Step application. Use the
Cisco 800 Fast Step CD-ROM and online help. If you are an experienced network administrator and want
to use the CLI to configure the software, refer to the Cisco 800 Series Routers Software Configuration
Guide.
Cisco 800 Series Routers Hardware Installation Guide
2-22
Normal Patterns
LINE, CH1, and CH2: On. CH1 or CH2 is
•
on when the router has an active voice
connection.
CH1 RXD, CH2 RXD: Blinking when
•
indicated ISDN B channel receives a
packet.
CH1 TXD, CH2 TXD: Blinking when
•
indicated ISDN B channel sends a packet.
1
On when telephone, fax, or modem is in use.
Chapter 2 Installation
78-5373-04