Configuration Tasks - Cisco 7304 Installation And Configuration Manual

Upgrading, Configuration, and Troubleshooting
Tasks
This chapter provides configuration and troubleshooting information. Troubleshooting information
includes general show commands, show and debug commands specific to the NSE, and the like. The
following topics are covered in this chapter:
•
•
•
•
•
•
•
•
•
•

Configuration Tasks

The PXF processors are turned on by default. If they are ever disabled, you must enable them to take
advantage of IP packet switching and feature acceleration.
Before enabling the PXF processors, you must have IP routing and IP CEF switching turned on.
Note
To manually disable or enable the PXF processors, use the global command:
hostname (config)# [no] ip pxf
For additional information on PXF processing, including a list of features supported in the PXF
processing path, see
OL-3967-01
Configuration Tasks, page 7-1
Upgrading ROMmon, page 7-2
Configuring Autoboot to Boot from the Network, page 7-4
Configuring Autoboot to Boot from a Local Device, page 7-4
Using the Bootldr Command, page 7-4
Using the show version Command, page 7-5
Using the show c7300 Command, page 7-6
Using Debugging Commands and PXF, page 7-7
Ethernet Pause Frames on the NSE Gigabit Ethernet Ports, page 7-7
Troubleshooting, page 7-8
PXF Information for the Cisco 7304
C H A P T E R
Router.
Cisco 7304 Network Service Engine Installation and Configuration
7
7-1