Supported Platforms; Nse-150 Description - Cisco 7304 Installation And Configuration Manual

NSE-150 Overview
This chapter describes the NSE-150 and contains the following sections:
•
•
•
•
•
•
•
For NSE-150 configuration information, see
Troubleshooting Tasks."

Supported Platforms

The NSE-150 is only supported on the Cisco 7304 router. The NSE-150 software support was introduced
in Cisco IOS Release 12.2(31)SB2.

NSE-150 Description

The NSE-150 is a processor for the Cisco 7304 router. It contains two internal processors for forwarding
network traffic: a Parallel eXpress Forwarding (PXF) processor, which accelerates the processing of IP
packets for features supported in the PXF processing path, and a Route Processor (RP), which handles
all non-IP packets as well as all packets that are not forwarded using the PXF processing path.
The NSE-150, which has four on-board Gigabit Ethernet interfaces, introduces additional Gigabit
Ethernet ports for the Cisco 7304 router. Additional on-board memory has also been added for the
NSE-150, allowing for faster processing of both PXF-processed and RP-processed traffic.
LEDs
NSE-150 LED information is in
OL-3967-01
Supported Platforms, page 2-1
NSE-150 Description, page 2-1
NSE-150 Memory Information, page 2-5
Gigabit Ethernet SFP Port and Cabling Specifications, page 2-6
USB Interface, page 2-10
Fast Ethernet Management Port Connections, page 2-10
Console and Auxiliary Ports, page 2-10
C H A P T E R
Chapter 7, "Upgrading, Configuration, and
Figure 2-1.
Cisco 7304 Network Service Engine Installation and Configuration
2
2-1