Cisco 1760 - VPN Bundle Router Hardware Installation Manual page 87

Appendix C Installing and Upgrading Memory and Packet Voice Data Modules
•
•
Use the show version command to see the router memory size. This command is
described in the
Overview" chapter.
Follow these steps to install a DIMM on the router motherboard:
During this procedure, wear grounding wrist straps to avoid ESD damage to the
Warning
router. Do not directly touch the backplane with your hand or any metal tool, or
you could shock yourself.
Locate the DIMM slot on the motherboard. See
Step 1
Step 2 Remove any existing DIMM by pulling the DIMM slot guides (shown in
Figure
Figure C-4
DIMM slot
Insert the DIMM into the DIMM slot, making sure that the notches on the edge of
Step 3
the DIMM are inserted over the bars inside the DIMM slot.
Handle DIMMs by the card edges only. DIMMs are ESD-sensitive components
Caution
and can be damaged by mishandling.
78-13342-03
32 MB
64 MB
"Amounts of Memory"
C-4) away from the DIMM and down toward the motherboard.
Installing a DIMM
2
DIMM slot guides
Cisco 1760 Modular Access Router Hardware Installation Guide
section of the
Figure C-3 on page
DIMM
1
2
Installing a DIMM
"Cisco 1760 Router
C-4.
C-5