Cisco 1751V Hardware Installation Manual page 42

Optional Installation Steps
Follow these steps to mount the router on a wall or other surface:
Install the two screws 3.75 inches (9.52 centimeters) horizontally apart on a wall
Step 1
or other vertical surface.
The screws should protrude 0.25 inches (0.64 centimeters) from the surface of the
wall.
Hang the router on the screws with either the left side or right side mounting
Step 2
brackets so that
•
•
If you install the screws in drywall, use hollow wall anchors (1/8 inch
Caution
by 5/16 inch) to secure the screws. If the screws are not properly anchored, the
strain of the cables connected to the router rear-panel connectors could pull the
router from the wall.
Cisco 1751 Router Hardware Installation Guide
2-14
The LEDs are visible to the user. The LEDs indicate the router operating
status, so the LEDs should be easily visible.
The power supply does not hang from its cable. If the power supply is not
supported, it might disconnect from the cable that connects it to the router.
Chapter 2 Installation
78-11258-04