Cisco 1751V Hardware Installation Manual page 21

Chapter 1 Cisco 1751 Router Overview
Table 1-2 Rear-Panel Connectors
Connector/Slot
Ethernet port
Auxiliary port
Console port
WIC/VIC slot
WIC/VIC slot
VIC slot
Power socket
Protective earth
78-11258-04
Label/Color
10/100-Mbps
ETHERNET
(yellow)
AUX
(black)
CONSOLE
(light blue)
SLOT 0
SLOT 1
SLOT 2
+5, +12, –12
VDC
Ground wire
Use the rear-panel LEDs (see
you have correctly connected all cables to the router.
Description
Router connection to the local Ethernet network. This
port autosenses the speed (10 or 100 Mbps) and duplex
mode (full or half) of the device to which it is connected
and then operates at the same speed and in the same
duplex mode.
Modem connection for remote configuration using
Cisco IOS software.
Terminal or PC connection for local configuration using
Cisco IOS software.
Supports either a Cisco WIC or VIC. For detailed
information, refer to the Cisco WAN Interface Cards
Hardware Installation Guide that comes with every
card.
Supports either a Cisco WIC or VIC. For detailed
information, refer to the Cisco WAN Interface Cards
Hardware Installation Guide that comes with every
card.
Supports one Cisco VIC. For detailed information, refer
to the Cisco WAN Interface Cards Hardware
Installation Guide that comes with every card.
Router connection to the external power supply.
Router connection to earth ground by using a green and
yellow 14 AWG ground wire.
Table 1-3) during router installation to confirm that
Cisco 1751 Router Hardware Installation Guide
Rear-Panel Ports and LEDs
1-5