Sd Management; Motion Detection - TRENDnet TV-IP572P User Manual

TRENDnet User's Guide

SD Management

These settings control the management of data on the SD card installed on the camera.
Set the files per page – 5-100 files. To delete a file, select the file and click the Delete
checkbox to delete the file. If you wish to format your SC card at any time., click the
Format SD Card

Motion Detection

These settings control the motion detection settings on the camera. Motion detection
allows you to designate an area in the cameras viewing angle to capture motion within
that area. All other areas will not be recorded. This is useful if you want to limit your
recording to a particular size.
© Copyright 2012 TRENDnet. All Rights Reserved.
button.
Click the Enable Video Motion checkbox to activate motion detection. There are two
main fields: Sensitivity and Drawing Mode. Sensitivity is based on the strength of the
motion in the designated area. 0% means the strength is low and the system moves up
incrementally to 100% full sensitive strength.
Drawing Mode provides two options. Once you select Draw motion area, take your
mouse and draw a rectangular area where you want the camera to detect the motion. If
you want to remove the motion detection area select Erase motion area and the red
blocked area will disappear. If you click the Clear
remove the motion detection area. If you click the Refresh Image
button it will do as said. This is useful when the camera is out of focus and comes back
into focus at a later stage. Once you have set all setting options click Apply.
TV-IP572P / TV-IP572PI
button too it will also
23