Table of Contents
Advertisement
IP Setting
This item allows you to select the IP address mode and set up the
related configuration. The default setting is DHCP mode enabled.
- DHCP: Select this option when your network uses the DHCP server.
When the camera starts up, it will be assigned an IP address from
the DHCP server automatically.
- Static IP: Select this option to assign the IP address for the camera
directly. You can use IP Setup to obtain the related setting values.
IP
Subnet Mask
Default Gateway
Primary/
Secondary DNS
- PPPoE: Select this option when you use a direct connection via the
ADSL modem. You should have a PPPoE account from your Internet
service provider. Enter the User Name and Password. The camera
will get an IP address from the ISP as starting up.
NOTE Once the camera get an IP address from the ISP as starting up, it
automatically sends a notification email to you. Therefore, when
you select PPPoE as your connecting type, you have to set up the
email or DDNS configuration in advance.
Enter the IP address of the camera. The default
setting is 192.168.10.30.
Enter the Subnet Mask of the camera. The
default setting is 255.255.255.0.
Enter the Default Gateway of the camera. The
default setting is 192.168.10.1. In most cases,
this would be your router's IP address.
DNS (Domain Name System) translates domain
names into IP addresses. Enter the Primary DNS
and Secondary DNS that are provided by ISP.
- 29 -
Advertisement
Table of Contents
