Table of Contents
Advertisement
3.3 Configuring the IP Address of the PC
If you are failed to access to the camera, please check the IP address of
your computer. When you connect the camera to your computer directly
to proceed with configuration of the camera, you need to set up the IP
addresses to be in the same segment for the two devices to communicate.
1. On your computer, click Start > Control Panel to open the Control
Panel window.
2. Double‐click Network Connection to open the Network Connection
window.
3. Right‐click Local Area Connection and then click Properties from the
shortcut menu.
4. When the Local Area Connection Properties window appears, select
the General tab.
5. Select Internet Protocol [TCP/IP] and then click Properties to bring up
the Internet Protocol [TCP/IP] Properties window.
6. To configure a fixed IP address that is within the segment of the
camera, select the Use the following IP address option. Then, enter an
IP address into the empty field. The suggested IP address is
192.168.10.x (x is 1~254 except 30), and the suggested Subnet mask is
255.255.255.0.
7. When you are finished, click OK.
- 18 -
Advertisement
Table of Contents
