TRENDnet TPL-310AP User Manual page 11

LED
PWR (Power)
PL (Powerline)
Note: LED color
indicates the strength
and quality of the
powerline connection
through the electrical
system
ETH
(Ethernet Port)
WIFI
(Wireless)
WPS
(WiFi Protected Setup)
*Note: The following factors may affect the powerline network's connection quality:

Noise – Generated by appliances that are connected to your electrical system through power outlets that have high
power consumption requirements. (e.g. Microwaves, ovens, blow dryer, iron, dishwasher, etc.) The quality of your
household electrical wiring may also cause additional noise on your electrical system.

Distance – Long lengths of electrical wiring through your electrical system between connected powerline adapters.
Button
Push/Hold for 2 sec
Sync
Push/Hold for 10 sec
WPS Push/Hold for 3 sec
Push/Hold for 1 sec
Reset
Push/Hold for 5 sec
Sequen
Color
ce
Green Solid
N/A Off
Solid
Green
Syncing or Powerline Data Transmitting/Receiving (Connection Quality is
Blinking
Solid
Amber
Blinking
Solid
Red
Blinking
N/A Off
Solid
Green
10/20Mbps, 100/200Mbps, or 1000/2000Mbps (Half/Full Duplex) Data
Blinking
N/A Off
Green Blinking
N/A Off
Green Blinking
N/A Off
Action
Initiate Sync/Connection and generate random network name/key on first
Match network name/key on secondary or additional adapter and connect to
Note: The secondary or additional powerline adapter's Sync button must also
be pushed within 2 minutes (120 sec) of pushing the Sync button of the first
Erases the network name/key (All LEDs will turn off and turn back on)
Reset to Powerline factory defaults only (All LEDs will turn off and turn back on,
Note: Will reset to the factory default private network name "HomePlugAV".
This will not reset Wireless Access Point settings and the settings will remain
Reset to Wireless Access Point factory defaults only (All LEDs will turn off and
Note: This will not reset Powerline settings and the settings will remain intact.
Powerline Connected (Connection Quality is Best)
Powerline Connected (Connection Quality is Better)
Powerline Data Transmitting/Receiving (Connection Quality is Better)
Powerline Connected (Connection Quality is Good)
Powerline Data Transmitting/Receiving (Connection Quality is Good)
Powerline is not synced or connected
10/20 Mbps, 100/200Mbps, or 1000/2000Mbps (Half/Full
Transmitting/Receiving
Port Disconnected/No Ethernet Link
Wireless is on or enabled / Wireless Data Transmission
Wireless is off or disabled
WPS is not activated or disabled
adapter (PWR LED will start blinking)
first adapter. (PWR LED will start blinking)
adapter in order to establish connectivity.
Activates Wi-Fi Protected Setup (WPS)
PL LED will blink Amber)
Definition
Device powered On
Device powered Off
Best)
Duplex) Connected
WPS is activated
Function
intact.
turn back on)