How To Connect Wireless Devices Using Wps - TRENDnet TEW-711BR User Manual

TEW-711BR
TRENDnet User's Guide

How to connect wireless devices using WPS

WPS (Wi-Fi Protected Setup) is a feature that makes it easy to connect
devices to your wireless network. If your wireless devices support WPS,
you can use this feature to easily add wireless devices to your network.
Note: You will not be able to use WPS if you set the SSID Broadcast
setting to Disabled.
There are two methods the WPS feature can easily connect your wireless
devices to your network.
 PBC (Push Button Configuration) Method
o Hardware Push Button - located physically on your router
o WPS Software/Virtual Push Button - located in router
management page
 PIN (Personal Identification Number) Method - located in router
management page
Note: Refer to your wireless device documentation for details on the
operation of WPS.
PBC (Hardware Push Button)
To add a wireless device to your network, simply push the WPS button on
the wireless device you are connecting, then push and hold the WPS
button located on your router for 3 seconds and release it. A blue LED on
your router WPS button will flash indicating that the WPS setup process
has been activated on your router. (See "Side Panel View" on
For connecting additional WPS supported devices, repeat this process for
each additional device.
© Copyright 2011 TRENDnet. All Rights Reserved.
page 4)
Wireless Networking
27