How To Set Up The Dhcp Server On Your Router - TRENDnet TEW-711BR User Manual

TEW-711BR
TRENDnet User's Guide

How to set up the DHCP server on your router

Main > LAN & DHCP Server
Your router can be used as a DHCP (Dynamic Host Configuration Protocol)
server to automatically assign an IP address to each computer or device
on your network. The DHCP server is enabled by default on your router. If
you already have a DHCP server on your network, or if you do not want to
use your router as a DHCP server, you can disable this setting. It is
recommended to leave this setting enabled.
1 Log into your router management page (see "How to access your
.
router management page" on
2. Click on Main, and click on LAN & DHCP Server.
3. Review the DHCP Server settings.

DHCP Server – Enable or Disable the DHCP server.

Start IP – Changes the starting address for the DHCP server range.
(e.g. 192.168.10.20)

End IP – Changes the last address for the DHCP server range. (e.g.
192.168.10.30)
Note: The Start IP and End IP specify the range of IP addresses to
automatically assign to computers or devices on your network.

Domain Name (Optional) – Specifies a domain name to assign to
computers or devices. (e.g. trendnet.com)

Lease Time – Click the drop-down list to select the lease time.
Note: The DHCP lease time is the amount of time a computer or device
can keep an IP address assigned by the DHCP server. When the lease time
expires, the computer or device will renew the IP address lease with the
DHCP server, otherwise, if there is no attempt to renew the lease, the
DHCP server will reallocate the IP address to be assigned to another
computer or device.
© Copyright 2011 TRENDnet. All Rights Reserved.
page 11).
4. To save changes, click Apply.
Dynamic DHCP List – You can view the list of active lease entries for
computers or devices that have been assigned IP addresses automatically
from the DHCP server on your router.
Advanced Router Setup
17