Troubleshooting; Problems With The Link Status - TRENDnet TEW-601PC User Manual

108mbps 802.11g mimo wireless pc card
Hide thumbs Also See for TEW-601PC:
Table of Contents

Advertisement

Troubleshooting

P
S
ROBLEMS
TARTING THE
PROBLEM
Windows does not
auto-detect the
TEW-601PC.
P
ROBLEMS WITH THE
PROBLEM
The link quality and/or
signal strength is poor all
the time from the status
bar.
P
ROBLEMS WITH
"Disconnected" (meaning
authentication failure)
Shown in the Status Bar
LED PWR and LINK are
on but cannot receive or
sending data and connect
to network
Problems Communicating With Other Computers
PROBLEM
The TEW-601PC
computer cannot
communicate with the
other computer.
802.11g W
Make sure the TEW-601PC power switch is turned off and properly inserted into
the PCMCIA slot and then restart your computer.
Perform a hardware scan by clicking Start, Settings, Control Panel and then
double-click Add/Remove Hardware. (Steps may vary depending on Windows
version).
Follow the on-screen instructions to search for the TEW-601PC and install the driver.
Check for possible hardware conflicts. In Windows, click Start, Settings, Control
Panel, System, Hardware and then click Device Manager. Verify the status of the
TEW-601PC under Network Adapter.
(Steps may vary depending on the Windows version).
Install the TEW-601PC in another computer. If the error persists, there may be a
hardware problem. In this case, please contact your local dealer for support.
L
S
INK
TATUS
Search and connect to another AP with a better link quality using the Site
Survey screen.
Change the channel used by your AP.
Move your computer closer to the AP or the peer computer(s) within the
transmission range.
There may be too much radio interference (for example microwave or
another AP using the same channel) around your wireless network.
Relocate or reduce the radio interference.
S
S
ECURITY
ETTINGS
Make sure your AP/Router has the same setting as your client adapter and
follow AP/Router's security settings.
Make sure your AP/Router has the same setting as your client adapter and
follow AP/Router's security settings.
Make sure you are connected to the network.
C
U
IRELESS
LIENT
TILITY
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
P
ROGRAM
Appendix -- 33

Advertisement

Table of Contents
loading

Table of Contents