TRENDnet TEW-432BRP Quick Installation Manual page 10

Fourth, press on the factory reset button for 15 seconds.
Q2: I am not sure what type of Internet Account Type I have for my Cable/DSL
connection. How do I find out?
A2: Contact your Internet Service Provider's (ISP) support service for the correct
information.
Q3: The Wizard does not appear. What should I do?
A3: First, click Wizard on the left hand side. Second, near the top of the browser,
"Pop-up blocked" message may appear. Right click on the message and select
Always Allow Pop-ups from This Site. Third, disable your browser's pop up blocker
Q4: I went through the Wizard, but I can not get onto the Internet. What should I
do?
A4: First, verify that you can get onto the Internet with a direct connection into your
modem. Second, contact your ISP and verify all the information that you have in
regards to your Internet connection settings is correct. Third, power cycle your
modem and router. Unplug the power to the modem and router. Wait 30
seconds, and then reconnect the power to the modem. Wait for the modem to fully
boot up, and then reconnect the power to the router.
Q5: I can not make a wireless connection to the Router. What should I do?
A5: First, make sure that the antennas are connected to the TEW-432BRP.
Second, double check that the WLAN light on the Router is lit. Third, power cycle
the TEW-432BRP. Unplug the power to the TEW-432BRP. Wait 15 seconds, then
plug the power back in to the TEW-432BRP. Fourth, contact the manufacturer of
your wireless network adapter and make sure the wireless network adapter is
configured with the proper SSID. The preset SSID is TRENDnet.
If you still encounter problems or have any questions regarding the TEW-432BRP,
please contact TRENDnet's Technical Support Department..
2. Click Internet Protocol (TCP/IP) and
then click Properties. Then click on
Use the following IP address, and
make sure you assign your network
adapter an IP address in the subnet of
192.168.10.x.
8