Ieee1394 Firewire; The 0202 Daughter Card; Connections; Analog Inputs And Outputs - E-Mu 1212M Owner's Manual

3 - PCI Card & Interfaces

The 0202 Daughter Card

Sample Rate Number of Audio Channels
44kHz/48kHz 8 channels of 24-bit audio
88.2kHz/96kHz 4 channels of 24-bit audio, using S/MUX standard
176.4kHz/192kHz 2 channels of 24-bit audio, using S/MUX standard

IEEE1394 Firewire

This port allows high speed data transfer between your computer and external storage
devices such as hard disks, CD-ROM drives, etc. Firewire ports are "hot-swappable"
which means that you can plug and unplug Firewire peripherals without turning off
power.
This port does NOT support Firewire audio. It is fully compliant with the OHCI 1.1
specification, supporting asynchronous and isochronous data transfers at 100, 200 or
400 Mbit/s with multiple DMA channels.
The 0202 Daughter Card
The 0202 Daughter card is the companion card for E-MU 1010 systems which don't
include the AudioDock. The 0202 Daughter card provides one pair of 24-bit balanced
analog inputs and one pair of 24-bit balanced analog outputs, plus MIDI in and out.

Connections

Left / Right
Line Inputs
Left / Right
Line Outputs
MIDI
In/Out

MIDI In/Out

The MIDI input and output port can be assigned in your specific MIDI application.
Connect the MIDI adapter cable that came with your 0202 Daughter card to the mini-
DIN connectors on the card. The adapter cables convert the mini-DIN to standard DIN
connectors used on most keyboards and synthesizers. Connect MIDI Out to the MIDI In
port of your synthesizer and MIDI Out of your synth to MIDI In of the 0202 Daughter
Card.
20

Analog Inputs and Outputs

The 0202 Daughter Card provides two balanced,
analog inputs and two balanced, line level analog
outputs. The inputs can be connected to any line level
stereo signal from keyboards, CD-players, cassette
decks, etc. The analog inputs are assigned to a mixer
strip in the mixer application.
The outputs can feed any line level input such as a
mixing board, the auxiliary input on your stereo or a
set of powered speakers. The line outputs are not
designed to drive headphones directly. Connect the
line outputs to a stereo receiver or mixer with a
headphone jack to obtain the proper current drive.
Either TRS (tip-ring-sleeve) balanced or TS unbalanced
cables can be used. Balanced cables provide better
noise immunity and +6dB higher signal level. The
output line level can be set to accommodate the
consumer -10dBV standard, or the pro audio +4 dBu
standard in the I/O screen of the Session Settings
dialog box. See I/O Settings.
Important: The 6-pin
Firewire connector/port
has a 3-watt maximum
power output. Connect
only one high power
usage device such as a
IEEE 1394 hard disk or
CD-RW drive to this port
unless it is self-powered.
Creative Professional