2 - Installation
Install the Sync Daughter Card or 0202 Daughter Card
Install the Sync Daughter Card or 0202 Daughter
Card
• E-MU 1820M - If you're planning to use Word Clock. MIDI Time Code or SMPTE
sync, unwrap the Sync Daughter Card and get ready to install it. If you don't need
these options or don't have an empty PCI slot, you can skip these next few steps.
• E-MU 0202M - Unwrap the 0202 Daughter Card and get ready to install it.
Connect the ribbon cable provided with the kit between the E-MU 1010 card and
1.
the 0202 Daughter card or Sync Daughter Card as shown in figures 3 & 4. The cables
are keyed so they cannot be incorrectly inserted. Seat the connectors firmly in the
sockets and arrange the cables neatly.
Align the Sync Daughter Card or the 0202 Daughter Card with the slot and press
2.
gently but firmly down into the slot as shown in figure 2 on the preceding page.
Do not force the E-MU Card into the slot. Make sure that the tab at the rear of the
3.
card is aligned with the PCI bus connector on the motherboard before you insert
the card into the PCI slot. If it doesn't fit properly, gently remove it and try again.
Secure the card into the slot using one of the screws you placed aside earlier.
4.
Figure 3
Sync Daughter
Card
14
Figure 4
0202 Daughter
Card
Creative Professional