Dell PowerEdge 2970 Hardware Owner's Manual page 22

Table 1-6. LCD Status Messages (continued)
Code Text
E1311 RPM Fan Mod ##
E1313 Fan Redundancy
E1410 CPU # IERR
E1414 CPU # Thermtrip
E1418 CPU # Presence
E141C CPU Mismatch
E141F CPU Protocol
22
About Your System
Causes
RPM of specified cooling fan is
out of acceptable operating range.
The system is no longer fan-
redundant. Another fan failure
will put the system at risk of over-
heating.
Processor # has had an internal
error (IERR) that is possibly, but
not always, caused by a problem
with the CPU.
Specified microprocessor is out of
acceptable temperature range and
has halted operation.
Specified processor is missing or
bad, and the system is in an
unsupported configuration.
Processors are in a configuration
unsupported by Dell.
The system BIOS has reported a
processor protocol error.
Corrective Actions
See "Troubleshooting System
Cooling Problems" on page 123.
Check control panel LCD for
additional scrolling messages. See
"Troubleshooting System Cooling
Problems" on page 123.
See "Getting Help" on page 147.
See "Troubleshooting System
Cooling Problems" on page 123.
If the problem persists, ensure
that the microprocessor heat
sinks are properly installed. See
"Troubleshooting the
Microprocessors" on page 133.
NOTE:
The LCD continues to
display this message until the
system's power cord is
disconnected and reconnected to
the AC power source, or the SEL is
cleared using either Server
Assistant or the BMC Management
Utility. See the Dell OpenManage
Baseboard Management
Controller User's Guide for
information about these utilities.
See "Troubleshooting the
Microprocessors" on page 133.
Ensure that your processors
match and conform to the type
described in the Microprocessor
Technical Specifications outlined
in your system's Getting Started
Guide.
See "Getting Help" on page 147.