Hard-Disk Drive Bracket; Figure 4-12. Hard-Disk Drive Bracket Removal - Dell Precision 400 Service Manual
Dell precision 400: service manual
Hide thumbs
Also See for Precision 400:
- Owner's manual (214 pages) ,
- User manual (170 pages) ,
- Documentation update (4 pages)
Table of Contents
Advertisement
4-12
Dell WorkStation 400 Systems Service Manual
Hard-Disk Drive Bracket
lower-back tab
Figure 4-12. Hard-Disk Drive Bracket Removal
To remove the hard-disk drive bracket, follow these steps:
1. Disconnect the DC power cable and the interface cable from the back of
each hard-disk drive installed in the hard-disk drive bracket.
2. Remove the screw that secures the hard-disk drive bracket to the front
of the chassis.
3. Grasp the handle on the front of the bracket, and rotate the front of the
bracket up until the hooks are free from the chassis.
4. Lift the hard-disk drive bracket out of the computer.
When you reinstall the hard-disk drive bracket, place the lower-back tab of the
hard-disk drive bracket into position (be sure that the opening in the lower-back
tab is over the alignment tab on the chassis); then rotate the front of the bracket
down into position.
hard-disk drive
bracket
handle
screw
Advertisement
Table of Contents
