Hardware Overview; Connections - D-Link DCS-5610 User Manual

Section 1 - Product Overview
DC Power Connector
The DC power input connector is located
on the DCS-5610 Internet Camera's back
panel and is labeled 12V DC with a single
socket to supply power to the Internet
Camera.
Ethernet Cable Connector (PoE)
The Internet Camera's back panel features an RJ-45 connector
for connections to 10Base-T Ethernet cabling or 100Base-TX Fast
Ethernet cabling. This network port supports the NWay protocol,
allowing the Internet Camera to automatically detect or negotiate
the transmission speed of the network. The Ethernet port can
also be used to power the camera using a PoE switch.
Microphone Connector
The DCS-5610 Internet Camera has an internal
microphone built-in. However, you have the option
of using an external microphone by plugging it into
the microphone connector.
D-Link DCS-5610 User Manual

Hardware Overview

Connections

Reset Button
Reset will be initiated when the reset
button is pressed once and held 30
seconds until the Power LED flashes
through its cycle twice.
MIC On/Off Switch
Used to turn the microphone on
or off.
Audio Out Connector
The DCS-5610 provides an Audio Out connector
to be used for 2-way audio. Speakers (not
included) may be connected to the camera to
provide audio for 2-way communication.
I/O Connector
The DCS-5610 provides a terminal block with two pairs of
connectors situated on the back panel. One pair is for input
and the other is for output. The I/O connectors provide the
physical interface to send and receive digital signals to and
from a variety of external devices.