Clavia Nord Modular G2 User Manual page 54

3. Working with the synth: Nord Modular G2 rear panel
S P
USTAIN EDAL
Connect a sustain pedal to the S
different types of Sustain Pedals.
USB C
ONNECTOR
The (1.1) connector is used to connect the G2 to a computer. Connect a free
USB
computer that runs the Editor software to the
MIDI I , MIDI O
N
Connect any external
a sequencer, a master keyboard or another
A O
UDIO UTPUTS
The unbalanced, line level (-10 dBV) audio outputs O
virtual mix buses in Nord Modular G2. Use O
mono sound system. If only O
A I
UDIO NPUTS
By connecting external sound sources to the unbalanced, line level (-10 dBV) inputs I
feed audio signals into the G2 and process the audio with any of the available G2 modules.
H
EADPHONES
The H
EADPHONES
Note! Since the G2 Engine lacks a volume knob, be careful when you use headphones so the
volume isn't too loud. Make it a habit of always lowering the Patch Level in the Editor before
using headphones with the G2 Engine.
XLR M
ICROPHONE
The M
XLR IC INPUT
I 1, it will automatically override and disable the M
NPUT
be sure no jack plug is connected to the I
to amplify the signal externally to use a dynamic microphone on this input. The G2X model comes with
a goose-neck microphone that can be readily plugged into the
G2 E
NGINE REAR PANEL
Note! The Control Pedal input, the Sustain Pedal input and the XLR Microphone input are not available
on the G2 Engine model.
Page 54
(G2, G2X)
P
USTAIN
MIDI T
UT AND HRU
equipment to the
MIDI
1 is connected, the audio from O
UTPUT
O
UTPUT
output routes audio signals which are assigned O
I (G2, G2X)
NPUT
can be used for dynamic, non-Phantom powered microphones. If you use the
NPUT
input. The polarity of the input can be adjusted to suit
EDAL
Port. The
USB USB
C
ONNECTOR
,
MIDI IN MIDI OUT
device.
MIDI
1-4 route the audio signals from the four
UTPUT
1 if you are going to use Nord Modular G2 with a
UTPUT
IC INPUT
1. The M has a built-in preamp so you don't have
IC INPUT
XLR
NORD MODULAR G2 V1.4x
port of the
USB
connection is hot-pluggable.
and ports. This could be
MIDI THRU
2 is mixed to O
UTPUT
NPUT
1 and 2.
UTPUT
. So, if you want to use a microphone
connector.
1.
UTPUT
1-4, you can