Device; Status - Clavia Nord Modular G2 User Manual

13. Module reference: In/Out group
G
ATE
This yellow output sends a
note-on is received at the M
MIDI
when the last key is released. You can use this signal to start envelopes in the single-trigger fashion. If a
sustain pedal is activated, the logic signal will be
V
EL
This blue output provides you with a control signal from the last/lowest/highest (depending on the
alternative above) note-on velocity. The velocity response of the Nord Modular G2 keyboard is linear
from this output. Signal: Unipolar Positive.
D
EVICE
The Device module represents a number of physical
controls on the synth and routes their respective control
signals for use in the Patch.
W
HEEL
The blue Wheel output provides a positive control signal according to the position of the M
Signal: U
NIPOLAR
A
FTERTOUCH
The blue Aftertouch output provides a positive control signal according to the current Keyboard
Aftertouch value. Signal: U
C P
ONTROL EDAL
The blue Control Pedal output provides a positive control signal according to the position of a connected
Control/Expression pedal. Signal: U
S P
USTAIN EDAL
The yellow Sustain Pedal output provides a logic
pedal is depressed. In the system menu you can set if the Sustain pedal is of a 'make-contact or 'break-
contact' type. Signal: L
P S
ITCH TICK
The blue Pitch Stick output provides both the negative and positive control signal range of the P
S . It will output a signal as soon as the P
TICK
Signal: B
IPOLAR
S
TATUS
The Status module is an extremely useful module for
controlling things in a Patch. It gives you the possibility
to control or define events on the moment when you
load a Patch (e.g. to send specific
Patch. It also gives you the possibility to control your Patch depending on which individual voice is used.
P A
ATCH CTIVE
Provides you with a logic
This signal can be used to reset or sync events in the Patch that you want to reset automatically after Patch
load. Signal: L
OGIC
Page 160
logic level (+64 units) every time a key is pressed on the keyboard or a
HIGH
I port. The logic signal switches back to a
IDI N
P .
OSITIVE
P
NIPOLAR OSITIVE
NIPOLAR
. See also Sustain Pedal Polarity at
OGIC
.
commands) and also when you switch between Variations in the
MIDI
signal (+64 units) as soon as a Patch is loaded into a Slot or activated.
HIGH
.
for as long as the pedal is pressed. Signal: Logic.
HIGH
.
P .
OSITIVE
signal (+64 units) as soon as a connected sustain
HIGH
"Sust Ped Pol |Sy" on page 32
S is moved.
ITCH TICK
NORD MODULAR G2 V1.4x
logic level (0 units)
LOW
OD
W .
HEEL
ITCH