Table of Contents
Advertisement
Installation
The installation procedures for the 10/100Mbps PCI
bus Fast Ethernet Card including hardware
installation,
BIOS
configuration, and driver installation.
Step 1, Hardware Installation
Power off the computer, unplug the power
1.
cord, and remove the computer's cover.
Select an unused PCI bus-master slot and
2.
remove its protective bracket.
Carefully insert the card and press until all the
3.
golden connectors are firmly seated inside the
slot. Secure the card's bracket on the PC's
chassis with a screw.
Attach the Wake-On-LAN cable (optional, for
4.
PCI 2.1 motherboard). If you require
Wake-On-LAN capability, attach one end of
the 3-pin Wake-On-LAN cable to the
connector on the top edge of the card, and the
other end to the "WOL" connector on the
motherboard. Refer to your computer's
installation manual to locate this connector.
Replace the computer's cover, connect the
5.
network cable to the newly installed network
card, and reconnect the computer's power
cord.
(on
the
motherboard)
6
Advertisement
Table of Contents
