Fitting Embroidery Unit; Removing The Embroidery Unit - Brother PC-8200 User Manual

Fitting embroidery unit

2

Removing the embroidery unit

Always turn off the power supply before carrying out the
procedure below.
1. Turn off the power.
1
2. Open the cover of the connecting slot by rotating the plastic
bracket in the direction indicated by the arrow.
1 Connecting slot
2 Plastic bracket
* When the embroidery unit is not being used, close the cover
of the connecting slot.
3. Insert the connector of the embroidery unit into the slot and
check that it is connected properly.
* Put the machine on a flat and horizontal surface and slide
the embroidery unit towards the machine.
1. Make sure that the embroidery frame has been removed,
touch the "EMBROIDERY" key or the "EMBROIDERY EDIT"
key, and then touch the "EMBROIDERY ARM STORAGE
POSITION" key. The carriage will move to the removal
position.
CAUTION
If the above procedure is not carried out, the embroidery
unit cannot be removed and placed in the case.
2. Turn off the power, hold the left side of the embroidery unit,
and while pressing the release button, gently slide the
embroidery unit away from the machine.
1 Release button
CAUTION
Make sure that the power is turned off, otherwise damage
1
may result.
101