Remote Control - Daewoo DP-42GM User Manual

Remote Control

The number in (
*
the function of each button is explained in detail.
Input Select button
Used to select a desired input.
Every press of the button
cycles through the five
different modes: Video 1 -->
Video 2 --> PC --> Component 1
--> Component 2
ZOOM button
Used to zoom the screen. To enlarge,
press the (+) button, and to return to
the previous condition, press the (-)
button. (ZOOM Mode: Zoom 0~20)
Menu Select button
Select Menu by pressing
(Down), (Left), (Right) buttons.
Screen Select button
Every press of the button cycles through the four different
modes: Normal --> Cinema --> Dynamic --> User.
Sound Mode button
Every press of the button cycles through the five different
modes: Normal --> Movie --> Music --> News --> User.
Mute button
Mutes sound.
When Using Remote Control:
•
Be sure not to allow the Remote Control to drop or to become wet.
•
Keep it away from hot or moist locations.
) indicates the page in which
INPUT
SELECT
44
ZOOM-
38
32
(Up),
31
PICTURE
41
Note
• Use two "AAA" batteries.
• Be sure to use replacement batteries of the
• The life of a battery depends on how much
POWER
Power button
DISPLAY
Display button
ZOOM+
Indicates the current state and resolution.
MENU
VOL VOL
Aspect Ratio
SCREEN
MODE MODE
FREEZE
Still
SOUND MUTE SLEEP
MODE
Sleep Timer
Installing the Batteries in your Remote Control:
•
To remove the cover, slide it outwards while pressing it down.
•
Place two batteries in the remote control by properly orienting
them, then close the cover.
same type as the original ones.
it has been used.
16
Pressing the Power button of the Monitor
allows the Display to be standby. (Red light
is shown in the Remote Control Sensor.)
At this time, if you press the Power button
of the Remote Control, the Display is
turned ON (Green light in the Sensor).
46
Menu button
42
Use to display a desired menu.
32
Volume button
Adjusts the volume.
34
Adjusts the size of the screen
(normal, 16:8, etc.)
40
Used to view a still picture during
watching moving images. (Sound
can be heard.)
49
Each time you press this button, a different
input mode appears.
The sequence is as follows:
15 Min. --> 30 Min. --> 60 Min. --> 90 Min. --> 120 Min. --> OFF
After the time is selected, it automatically
becomes stand-by state.
13