Table of Contents
Advertisement
Functional
Overview
POWER
STILL
RECALL
LOCK
SLEEP
SOUND
EDIT
MODE
PICTURE
ASPECT
PREV PR
MENU
PIP
POSTION
SWAP
INPUT
Remote Controller
1.
(MUTE) : Press this button, and the sound goes off.
Press again, and the sound returns.
2.
(POWER) : TV on/off button in Stand-By mode.
Note: When the current state is ST-BY, you turn on the
TV using the digit key
3. STILL : Press this button to freeze the picture.
4. RECALL : The present modes(TV, Video, Component,
PC) and Signal information for 4 seconds.
In TV mode, the Programme number, Signal, PIP/POP,
MGDi and Current Time are displayed.
5. NUMBER : Press the numbers on this board, you can
select channels directly in TV mode. (EX. When you
want to select PR10, you should press down "1" and
"0" within 2second. If you only press down "1" , after
2 second, PR1 will be selected.)
Note: When the current state is ST-BY, you can turn on
the TV using the digit key. Then, PROGRAMME is
selected according to digit number.
6. LOCK : This prevents the use of the TV set without the
remote control.
7. SLEEP : Sleep Timer setting. (Sleep 10 > Sleep 20 >
Sleep 30 > Sleep 60 > Sleep 90 > Sleep 120)
8.
(MTS): You can select sound mode in Mono,
Stereo, Dual1, Dual2, NiCAM STEREO. It works only in
TV mode.
9. EDIT : You can enter the channel edit mode.
10. SOUND MODE : Using the this button, Select the
desired sound mode.
Standard > Music > Cinema > News> Favourite
11. PICTURE MODE : Picture modes change as follows :
Standard / Dynamic / Cinema / Favourite
8
Advertisement
Table of Contents
