Connections; Connecting Antenna/Cable; Connecting A Tv - Daewoo DRT-10 Instruction Manual

0817DTBD-LN11PA-AGN(GB) 2006.8.17 4:8 AM ˘ ` 17

Connections

Connections
• There are a variety of ways to connect the
DVB-T DVD Recorder to your TV and other
equipment. Use only one of the connections
described below. Whichever TV connection
you use will work with all input sources.
• Please refer to the manuals for your TV, VCR,
stereo system, or other devices as necessary to
make the best connections.
• For better sound reproduction, connect the
DVB-T DVD Recorder's AUDIO OUT jacks to the
audio in jacks of your amplifier, receiver,
stereo, or audio/video equipment. See
'Connecting an Amplifier/Receiver' on page 18.
Caution
• Make sure the DVB-T DVD Recorder is
connected directly to the TV, and the TV is set
to the correct video input.
• Do not connect the DVB-T DVD Recorder's
AUDIO OUT jack to the phone in jack (record
deck) of your audio system.
• Do not connect the DVB-T DVD Recorder via
your VCR. The DVD image could be distorted
by the copy protection system.

Connecting Antenna/Cable

1
Disconnect the antenna/cable from the rear of
your TV.
2
Connect this cable to the jack marked ANT IN
(FROM ANT.) on the rear panel of the DVB-T
DVD Recorder.
Antenna
Flat Wire
(300ohm)
300/75ohm Adapter
(Not supplied)
Rear of DVB-T DVD Recorder
If your cable wire is connected to your TV without a
converter or descrambler box, unscrew the wire
from your TV and attach it to the RF IN (FROM ANT.)
jack on the rear panel of the DVB-T DVD Recorder.
Use the supplied RF cable to connect between the
DVB-T DVD Recorder's OUT (TO TV) jack and the
antenna input jack on your TV. With this connection,
you can receive all midband, superband, and
hyperband channels (all cable channels).

Connecting a TV

Choose one of the following TV connections,
depending on the capabilities of your equipment.
RF Connection
Connect the ANT OUT (TO TV) jack on the DVB-T
Antenna
DVD Recorder to the antenna in jack on your TV
Cable TV
Wall Jack
using the supplied 75-ohm RF cable (R).
OR OR
Scart Connection
1
TV
VCR/DVD
2
Rear of TV
S-VIDEO
COMPONENT/PROGRESSIVE VIDEO INPUT
INPUT
Y
Pr Pb
S C V
TV
VCR/DVD
Rear of DVB-T DVD Recorder
This set doesn't have a modulator output. However
it still applies the RF through Output.
Plug a scart cable into the scart socket TV
(EURO AV1) at the back of the DVB-T DVD
Recorder and the corresponding scart socket at
the back of the TV set. (V)
Plug a scart cable into the blue scart socket
VCR/DVD (EURO AV2/DECODER) at the back of
the DVB-T DVD Recorder and the corresponding
scart socket at the back of the Decoder.
ANTENNA
INPUT
R
17