Environment Menu - BenQ PE7800 User Manual

3. PC&HDTV: The following settings are only available with a PC or Digital Television RGB signal:
AUTO: Adjusts the phase, frequency and position automatically.
FREQ.: Adjusts the frequency of the sampling clock that captures the input signal.
PHASE: Adjusts the phase of the clock.
H. POS.: Adjusts the horizontal position of the image.
V. POS.: Adjusts the vertical position of the image.
The available adjustment range of the vertical position depends on the type of the input signal that is being
displayed. The vertical position cannot be changed with some types of signal.
4. SAVE: There are three video memories in which users can store
settings, including all items in the Picture and Pro-Picture menus
except for SET USER COLOR TEMP.
Input source
VIDEO
S-VIDEO
COMP-HD
DVI-ANALOG/ DIGITAL
To store the settings:
i.) Adjusts the items in the Picture and Pro-Picture menus to desired values.
ii.) Go to the Display menu and select SAVE, press Enter. The SAVE OSD will be shown as the picture
above.
iii.) Select MEMORY 1, MEMORY 2 or MEMORY 3 and press ENTER to sore the settings.
iv.) To leave the OSD, press MENU.
5. LOAD: Loads the settings from one of three video memories.

ENVIRONMENT Menu

In this menu, global settings for the projector can be made.
There are four items available: DEFAULT — LAMP TIMER — AUTO OFF — LAMP HOURS.
1. DEFAULT: Loads the default value of the current input source.
2. LAMP TIMER: Resets the lamp timer. This should only be done after the lamp has been replaced.
3. AUTO OFF: Sets the auto-shutdown timer. The timer can be set to a value between10 minutes and 3 hours.
4. LAMP HOURS: Please refer to page 30 for detailed information.
26 Menus
Number of available memories
3
3
3
3