Table of Contents
Advertisement
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor
or switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends
a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled "Chassis Signal" and "Ground" are shorted
with a jumper cap. Remove the jumper cap only when you intend to
use the chassis intrusion detection feature.
®
Chassis Intrusion Connector
11. TV-out connector (6-1 pin TV-C)
This 6-1 pin connector is for the TV-out port module that allows you to
connect a television to your system. Connect the TV-out module to
this connector, then install the module to a slot opening at the back
of the system chassis.
®
TV Out Connector
The TV-out module is purchased separately.
ASUS Vintage V2-PH2
CHASSIS
(Default)
TV-C
1
4-11
Advertisement
Table of Contents
