Table of Contents
Advertisement
3
IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal
cable(s). There are three connectors on each Ultra DMA 133/100/66
signal cable: blue, black, and gray. Connect the blue connector to
the motherboardʼs IDE connector, then select one of the following
modes to configure your device(s).
®
IDE Connectors
Single device
Two devices
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE
devices.
If any device jumper is set as "Cable-Select", make sure all other device
jumpers have the same setting.
ASUS Vintage V2-PH2
PIN 1
Drive jumper
setting
Cable-Select or
Master
Cable-Select
Master
Slave
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
Mode Cable of
device(s)
-
Master
Slave
Master
Slave
Cable connector
Black
Black
Gray
Black or gray
4-7
Advertisement
Table of Contents
