Rinse Aid; Pour In Rinse Aid; Select Dosage - Asko D3121 Use And Care Manual

Rinse aid

Pour in rinse aid

Rinse aid, helps quicken the drying
process. There is a refill indicator in the
middle of the dispenser (see picture). If the
refill indicator is totally black, there is suffi-
cient rinse aid. However, if the indicator has
a more transparent appearance, you need
to top up with rinse aid.
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser.
This is where you top up and set the
amount of rinse aid to be dispensed in each
wash.
2. Fill until the indicator is totally black and
change the dosage as follows if required.
Do not forget to close the cover.

Select dosage

The dispenser is usually set at 1= soft water.
However, depending on the water hard-
ness, it may be necessary to change the
dosage.
Open the rinse aid cover . Here you will find
the dispenser's adjustment dial. Settings 1-
6: the harder the water, the higher the dos-
age.
Where the water hardness exceeds 10-
12 o dH you should use rinse aid with citric
acid (acid rinse aid) if the dishwasher does
not have a water softening filter. If the dish-
washer has a water softening filter, dis-
pense as for soft water.
Too much rinse aid can lead to the build-up
of foam. If your water is particularly soft, you
can dilute the rinse aid (1 part rinse aid, 1
part water).
Too much rinse aid can cause streaks on
the dishes, while too little can result in water
stains.
2 0
Open
Refill indicator
Cover for rinse aid
Open by turning and lifting the cover!
Closed