AMX Modero NXD-CV10 Operation/Reference Manual page 25

2. Grasp the end of the Modero Table Top cable being connected to the panel. This end of the cable is
longer than the opposing end which connects to the breakout box (6 inches vs 3 inches). Refer to
FIG. 15 for more detailed information.
3. Insert the shrink-wrap section of the cable into the groove along the inside of the ferrite enclosure.
The CAT5 Suppression Ferrite MUST be installed onto the shrink-wrap section of the
cable, at the location just before the cables split-off and separate.
4. Snap the enclosure shut with the shrink-wrap inside, and proceed to the installation of the second
Suppression Ferrite onto the USB mouse cable.
5. Follow these similar procedures to install the additional cylindrical CAT5 USB Mouse Suppression
Ferrite (04-0018-SA):
3
2
To Touch
Panel
Connector 1 - used for Audio/Video (Black)
Connector 2 - used for Ethernet (White)
FIG. 15 CV10 Ferrite connector location on the Table Top and mouse cables
10" Modero Widescreen Touch Panels
Locate the USB mouse device that will be connected to the rear USB connector on the NXT
panel.
Choose a location on the cable (closest to the connection point on the touch panel) and insert
it into the groove along the inside of the cylindrical enclosure.
Snap the enclosure shut with the USB cable inside, and you're done.
1
Ferrite
6 inches
Connector 3 - used for Power
CV10 Touch Panel Accessories
To Touch
Panel
Mouse
15