Command Format And Answer Format; Protocol For Data Transmission And Reception; Basic Procedure - Denon DVD 3800BDCI - Blu-ray Disc DVD/CD Player Specifications

Ver.3.09
Data : Mar.24.2008
1.3

Command format and answer format

This unit shall be based on commands each of which consists of a data row
are without a PC )
trans-mitting station shall be designed to send block check characters
with the data row enclosed in STX
The receiving station shall regard receipt of BCC as the completion of command reception when it
has received STX.
Here are the formats.
Commands
<BCCL>
STX (Start of TeXt)
CC (Command Code)
PC (Parameter Code)
ETX (End of TeXt)
BCC (Block Check Character)
Answers : <STX> <RC> <AC> <PC0> <PC1> <PC2> <--------> <PCn> <ETX> <BCCH> <BCCL>
STX (Start of TeXt)
RC (Reply Code)
AC (Answer Code)
PC (Parameter Code)
ETX (End of TeXt)
BCC (Block Check Character)
1.4

Protocol for data transmission and reception

This unit is based on half-duplex communication. The unit shall therefore transmit commands
and receive answers according to the following procedure.
1.4.1

Basic procedure

1)
The host shall select commands for this unit and transmit them to this unit. Command
interval time is MIN 40µsec.
2)
Having issued a command, the host shall receive an answer from this unit, then issue the
next command.
3)
The host shall analyze the RC, AC, and PC as answers given and decide whether the
command has been normally executed.
4)
The host shall give an answer to a command that gives operational instructions, then
issue a status request command, and decide whether this unit has finished operating with
Copyright 2008
composed of command codes
( text start : 02h )
: <STX> <CC> <PC0> <PC1> <PC2> <---------> <PCn> <ETX> <BCCH>
CC + PC0 + PC1 + PC2 + --------------- + PCn + ETX = XYh
(Each of X and Y is 4 bit long )
BCCH ( high-level byte ) = X as converted to an ASCII code
BCCL ( low-level byte )
RC +AC + PC0 + PC1 + PC2 +
(Each of X and Y is 4 bit long)
BCCH ( high-level byte ) = X as converted to an ASCII code
BCCL ( low-level byte )
( CC ) and parameter codes
and ETX
: 02h
: Command code
: Defined for each command
( contents and number of parameters )
: 03h
:
X , Y=0,1,2,3,4,5,6,7,8,9,A,B,C,D,E,F
= Y as converted to an ASCII code
: 02h
: Reply code (=Command code)
: Answer code
: Defined for each command
( contents and number of parameters )
: 03h
:
-------------
X , Y=0,1,2,3,4,5,6,7,8,9,A,B,C,D,E,F
= Y as converted to an ASCII code
6 page of 50
( some commands
( PC ) . The
( BCC ) following ETX,
( text termination : 03h ) .
+ PCn + ETX = XYh