Attaching a USB Cable
Do This
4 Plug the end of the
cable with the
Motorola logo into the
phone's accessory
connector port. Make
sure that the logo and
the phone are both
facing you.
5 Plug the other end—the USB connection—into
the USB port on the external device.
Install the Software
Install the software from the CD-ROM that comes with
your Motorola Original data kit. See the data kit's user
guide for more information.
Sending a Data Call
Use this procedure to send data from a connected device,
and to synchronize phonebook and datebook information
between your phone, computer, and/or hand-held device.
Connect your phone to the device as described on
page 131 and do the following:
Do This
1 Check the phone make sure that the phone is
2 Open the
3 End the call from
133
134
To
connected and powered on
place the call through the
application on
application (such as
your computer
dial-up-networking)
Note: You cannot dial data
numbers through your
phone's keypad. You must
dial them through your
computer.
close the call and connection
the connected
when the transfer is complete
device