Aiwa NSX-MA945 Operating Instructions Manual page 17

If there is a 4-second or longer blank between each track, a search
for the beginning of the current or next track during playback can
be done easily,
Press + or * during playback referring to the playback side
indicator (4 or ~) on the display.
For example, when W is pressed while ~ is displayed, playback
of the next track starts.
Music sensor function may not be able to detect tracks under the
following conditions:
o Blanks of less than 4 seconds between tracks
Noisy blanks
Long passages of low-end sound
Low overall recording levels
Deck 1
3
After playback on one deck finishes, the tape in the other deck
will start to play without interruption.
1
2
3
4
Insert tapes into deck 1 and deck 2.
Press TAPE DECK 1/2 to select the deck to be
played back first.
Press REV MODE (DECK 2) to select 1).
Press -4> to start playback.
Playback continues until is pressed,
About cassette tapes
To prevent accidental erasure, break off the phastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A II
1
Type
II
tape
-Tab for !side A
detection
I
slot
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type
II
tapes, take care not to cover
the Type
II
tape detection slot,)
c
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recc]mmendad.
" Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism,
DOLBY NR system
The Dolby Noise Reduction system reduces tape hi:ssnoise.
For optimum performance when playing back a tape recorded
with the DOLBY NR system, turn on the DOLBY NR system.
ENGLISH 17