Acer S5201M Series Service Manual page 39

(4) Disassemble the
screw*3(M3*L6) connecting the
4
F/C with the RF board
(TRANSFER BD).(Figure5).
(1) Disassemble the screws*6
(STAND OFF XH4#-40*6L) and
then take off the R/C.(Figure1).
(2) Disassemble the screws*5
5
(M3*L6) and loose the wires
connecting the engine and the
main board, and then take off the
SHD of the main board(Figure2).
(1) Extract all the wires in the
main board and loose the wire in
6 clips.(Figure1)
(2) Take off the ourlet case and
the Fans*2.
(3) Take off the main board.
7
Attention: DON'T TWIST THE
PIN UNDER THE MB.
Figure5
Note: Circuit boards > 10cm
rectangle as above image shows. Please detach the Circuit boards
and follow local regulations for disposal.
Figure1
Figure1
CW wire
inlet fan
wire
CW 3pin wire
speaker wire
IR wire
ballast 5pin
wire
Main BD
Note: Circuit boards > 10cm
rectangle as above image shows. Please detach the Circuit boards
and follow local regulations for disposal.
39
RF BD
2
has been highlighted with the yellow
Figure2
5
RF BD wire
blower wire
outlet speaker wire
twins fan wire
2
has been highlighted with the yellow
screw
driver
loose these wires
1
2
3
screw
driver
4
screw
driver