9. Wait about 2~4 minutes
10. LED Lamp/Temp
11. When download fail, please back to step 7 and try again.
12. After download success, open factory menu page 7 again to check if the Pen version has
changed.
13. Check if Pointblank function works normal.
AP firmware download
1. Serve a VGA input to projector
2. Enable PB function in user menu
3. Enter factory menu page 7
4. You will see AP/Pen firmware version. Pen version display only when it connects to
projector.
5. select PB F/W Load Target to AP
6. select PB F/W Load Start and press Right button
off (download success), Lamp/Temp
red (download fail)
36