Ulead PYRO1394DV User Manual page 17

Connecting a 4-pin to 4-pin IEEE-1394 cable to a notebook computer
Checking the hardware setup
After connecting your digital camcorder to the computer, check if
the device is detected by your Windows system. If you installed an
IEEE-1394 card on your computer, check also if the card is
detected.
To check if the IEEE-1394 card and digital camcorder are
detected:
1. Insert your video tape into the
camcorder and switch it on. Make
sure it is in playback mode
(usually named VTR or VCR).
Check your camcorder's manual
for specific instructions.
2. Open the Control Panel, then open System: Hardware -
Device Manager.
3. Make sure the following device names are listed in the Device
Manager.
Under Windows XP or Windows Me:
• 1394 Bus Controller
• <Brand name> DV Camcorder (The brand name depends on
the DV camcorder connected to the IEEE-1394 interface.)
Under Windows 2000 or Windows 98SE:
• 1394 Bus Controller
• Image Device: Microsoft DV Camera and VCR (For Microsoft
DV driver only.)
ULEAD VIDEOSTUDIO USER GUIDE
17