3Com OfficeConnect 3CRWE454A72 User Manual page 15

In each of these cases, wait until the Access Point has completed the
current operation and the alert LED is Off.
Flashing slowly - The Access Point has completed the Reset to Factory
Defaults process, and is waiting for you to release the reset button. The
Access Point will then enter the start-up sequence and resume normal
operation.
If you have used the reset button to reset the unit to Factory Defaults,
follow steps 5 to 6 in
Defaults" on page
Continuously on - A fault has been detected with your Access Point
during the start-up process. Refer to
2 Power LED
Green
Indicates that the Access Point is powered on.
3 Wireless LAN (WLAN) Status LEDs
Yellow
There are two LEDs, one for 11a and one for 11g. If an LED is flashing it
indicates that wireless networking is enabled. The LED is flashing shows
that data is being transmitted or received. If the LED is off, the Wireless
LAN has been disabled in the Access Point, or there is a problem. Refer to
Chapter 5 "Troubleshooting".
4 LAN Status LED
Green (100Mbps link) / yellow (10Mbps link)
If the LED is on, the link between the port and the next piece of network
equipment is OK. If the LED is flashing, the link is OK and data is being
transmitted or received. If the LED is off, nothing is connected, the
connected device is switched off, or there is a problem with the
connection (refer to
automatically adjust to the correct speed and duplex.
"Forgotten Password and Reset to Factory
50.
Chapter 5
Chapter 5 "Troubleshooting"). The port will
Front Panel
"Troubleshooting".
15