Connecting To The Console & Auxiliary Port Of The Router; Console Port - D-Link Router DI-3660 Installation Manual

DI-3660 Router
Connecting to the Console & Auxiliary Port of the Router
There is one Console port and one AUX port on D-Link DI-3660 Router. This section describes the features and usage of these
two ports.

Console Port

Transmission Rate supported is 1200bps-to-115200bps and it has a standard RJ45 Connector, Parity Check is optional, and has
Flow Control. A dedicated Console cable, DRC-0001, provided with the router is used to connect this port to a terminal device
like VT-100, or to the serial port of PC, and then use a terminal emulator (such as Windows Hyper terminal software) to
configure & monitor the D-Link DI-3660 Router functions. The communication parameter of the serial port on a PC has to be
set as: Rate: 9600bps rate, eight-bit data bits, one-bit stop bit, no Parity Check bit, and no flow control as shown in Figure :
The RJ-45 connector of the Console port is shown in the following figure, the male and female connectors are pin-to-pin
corresponding and the pin numbers 1-8 start from left to right.
The connection between the Console port of D-Link DI-3660 Router and the terminal device or PC serial port is illustrated as
below:
__________________________________________________________________________________________________________________
15