Changing The Mw Channel Step For Use In Foreign Countries - Sony ICF-SW1000TS Operating Instructions Manual

Changing the MW channel step for use in
foreign countries
The MW channel step of this unit is factory-
set to 9 kHz. The channel step differs
depending on the area to match the frequency
allocation system of the country. Change the
MW channel step as necessary.
North and South American countries:
10 kHz
Japan, Europe, and other countries:
9 kHz
Notes
• When you have entered
the wrong MW channel
step in step 3, press
DIRECT to cancel the
current entry and enter
the correct value.
• "TRY AGAIN!" flashes
when the MW channel
step entered is invalid
(i.e., not 9 or 1 and 0).
Repeat from step 2
again.
• Complete each button
operation in steps 2 to 4
within 10 seconds. If
the clock display
returns, repeat from
step 2 again.
1
Turn off the radio.
2
Press DIRECT.
AM
3
Press the numeric buttons (1, 9 and 0) to enter the
desired MW channel step (9 or 1 and 0).
4
Press EXE.
AM
The MW channel step flashes for about 3 seconds and
then the clock display returns.
1 2 3
4 5 6
7 8 9
0
DIRECT EXE
kHz
FWD
kHz
FWD
19 EN
Radio