Information You Will Need From Your Adsl Service Provider - D-Link DSL-G624T User Manual

Security for wireless communication can be accomplished in a number of ways. The DSL-G624T supports WEP
encryption, 802.1X authentication, and WPA (Wi-Fi Protected Access). Wireless access can also be controlled by
selecting MAC addresses that are allowed to associate with the device. Please read the section on Wireless
Configuration.
Additional Software
It may be necessary to install software on your computer that enables the computer to access the Internet. Additional
software must be installed if you are using the device a simple bridge. For a bridged connection, the information needed
to make and maintain the Internet connection is stored on another computer or gateway device, not in the Router itself.
If your ADSL service is delivered through a PPPoE or PPPoA connection, the information needed to establish and
maintain the Internet connection can be stored in the Router. In this case, it is not necessary to install software on your
computer. It may however be necessary to change some settings in the device, including account information used to
identify and verify the connection.
All connections to the Internet require a unique global IP address. For bridged connections, the global IP settings must
reside in a TCP/IP enabled device on the LAN side of the bridge, such as a PC, a server, a gateway device such as a
router or similar firewall hardware. The IP address can be assigned in a number of ways. Your network service provider
will give you instructions about any additional connection software or NIC configuration that may be required.

Information you will need from your ADSL service provider:

Username
Password
WAN Setting /
Connection Type
Modulation Type
DSL-G624T Wireless ADSL Router User Guide
This is the Username used to log on to your ADSL service
provider's network. It is commonly in the form −
user@isp.co.uk Your ADSL service provider uses this to
identify your account.
This is the Password used, in conjunction with the Username
above, to log on to your ADSL service provider's network.
This is used to verify the identity of your account.
These settings describe the method your ADSL service
provider uses to transport data between the Internet and
your computer. Most users will use the default settings. You
may need to specify one of the following WAN Setting and
Connection Type configurations (Connection Type settings
listed in parenthesis):
PPPoE/PPoA (PPPoE LLC, PPPoA LLC or PPPoA VC-Mux)
Bridge Mode (1483 Bridged IP LLC or
1483 Bridged IP VC-Mux)
Static IP Address (Bridged IP LLC, 1483 Bridged IP VC-Mux,
1483 Routed IP LLC, 1483 Routed IP VC-Mux or IPoA)
Dynamic IP Address (1483 Bridged IP LLC or 1483 Bridged IP
VC-Mux)
Default = PPPoE/PPPoA (PPPoE LLC)
ADSL uses various standardized modulation techniques to
transmit data over the allotted signal frequencies. Some
users may need to change the type of modulation used for
their service. The default DSL modulation (ADSL2+ Multi-
Mode) used for the Router automatically detects all types of
ADSL, ADSL2, and ADSL2+ modulation. However, if you are
vi
Record info here