Virtual Server - D-Link DSL-G624T User Manual

To enable UPnP for any available connection, click to check the Enable UPnP selection box, select the connection or
connections on which you will enable UPnP listed under Available Connections and click the Apply button.

Virtual Server

Use the Virtual Server window to set up single-port, trigger port or static-port range forwarding rules applied to
inbound (WAN-to-LAN) traffic. The Virtual Server function allows remote users to access services on your LAN such
as FTP for file transfers or SMTP and POP3 for e-mail. The DSL-G624T will accept remote requests for these services
at your Global IP Address, using the specified TCP or UDP protocol and port number, and then redirect these requests
to the server on your LAN with the LAN IP address you specify. Remember that the specified Private IP Address must
be within the useable range of the subnet occupied by the Router.
UDP/TCP port redirection is used to direct inbound traffic to the specified servers or workstations on your private
network. Port redirection can also be used to direct potentially hazardous packets to a proxy server outside your firewall.
For example, you can configure the Router to direct HTTP packets to a designated HTTP server in the DMZ. You can
define a set of instructions for a specific incoming port or for a range of incoming ports. Each set of instructions or rule
is indexed and can be modified or deleted later as needed.
The Virtual Server options include a list of preconfigured rules (listed below) for commonly used protocols in the
Virtual Server List. To enable a preconfigured rule, click the selection box for the rule you want to enable and click the
Apply button.
Use the LAN Clients window to select eligible IP addresses before configuring forwarding
rules.
Note
DSL-G624T Wireless ADSL Router User Guide
Virtual Server window
9